Arcam A/V Processor XETA 2 Uživatelský manuál

ARCAMARCAM tJiCAL Ch£MA HALL TAPE LD SAT VCR AUXOOO O OOOOPROLOGC DOLBY 3 STEREO STEREO OOOPOWEROOME CINEMA PROCESSORг^r\o<JL>O'XETA 2

CONNECTION:You may choose between TAPE LOOP or LINE I/P (POWER AMP if AMPLIFIER is set to POWER AMP).Select the CONNECTION that you intend t

REMOTE CONTROL COMMANDSMost functions on the remote control are straightforward and obvious to use. The On ScreenGraphics win confirm their actions on

AMPLIFIER MODES (selected on screen in SET UP MODE)® REAR +/-: Trims the level of the rear surround speakers.Note: Not all films are encoded fiar surr

GENERAL ADVICE WHEN USING THE XETA 2USING AN OUTBOARD DACTurn your TV volume down or mute its internal speaker, otherwise it will upset

INITIAL ADVICEPlease ensure that you have read the instructions and are operating the equipment accordingly.Check aU cables to your speakers and other

FAULT FINDING ContinuedSYMPTOM:THINGS TO CHECK:SYMPTOM:ADVICE:XETA 2 DOES NOT RESPOND TO REMOTE CONTROL COMMANDS• The Xeta 2 may be set

Xeta 2 • Technical SpecificationContinuous power output per channelCentre 8Q, 20Hz - 20kHz4Q, 20Hz - 20kHz 8Q, IkHz 4Q, IkHzTHD, IkHz, 80% maximum

Issue 0196/1ARCAMPembroke Avenue, Waterbeach, Cambridge, CBS 9PB, England. Telephone: +44 (0)1223 440964 Fax: +44 (0)1223 863384Part No. SH049

© @ ® @ ® (§) ®oI----- 22W - amH n t»Vr-WX) CO Wl« sw rowER10 MK WCB VKnnnnann<B)&®-9*T HOE1 -VOUC«OEZIll=l oARCAMPROBLEMS?If your dealer is un

INTRODUCTIONSYSTEM CONFIGURATION ... Page 1INSTALLATION ...

2. USING THE XETA 2 AS AN INPUT EXTENDER FOR AN SOURCES (see figure 2)Figure 2 shows the suggested wiring for use with a power ampHfier (e.g. an Arca

INSTALLATIONMAINS SUPPLY CONNECTIONS® Check that your mains supply voltage agrees with the voltage setting indicated on the rear panelof the unit.

CONNECTING YOUR SOURCE COMPONENTSCOMPOSITE VIDEO CONNECTIONS (See figure 5) Audio inputs: Up to five different audio sources can be connect

® MONITOR OUTPUT - Connect this output to your TV’s composite video input. Most TVs only have SCART sockets; others use a phono

If this is not the case, try other inputs and/or recheck your system connections. The FAULT FINDING GUIDE on page(s) 12, 13 will also h

CentrePlay back a recording from the source you have selected. Aim to peak just into the white bars above the arrow during the l